杨兵, 黄贵存, 李尚贵. 川西高温压裂液室内研究[J]. 石油钻采工艺, 2009, 31(1): 117-120.
引用本文: 杨兵, 黄贵存, 李尚贵. 川西高温压裂液室内研究[J]. 石油钻采工艺, 2009, 31(1): 117-120.
YANG Bing, HUANG Guichun, LI Shanggui. Laboratory research of high temperature fracturing fluid in west Sichuan[J]. Oil Drilling & Production Technology, 2009, 31(1): 117-120.
Citation: YANG Bing, HUANG Guichun, LI Shanggui. Laboratory research of high temperature fracturing fluid in west Sichuan[J]. Oil Drilling & Production Technology, 2009, 31(1): 117-120.

川西高温压裂液室内研究

Laboratory research of high temperature fracturing fluid in west Sichuan

  • 摘要: 针对川西压裂液体系耐温性能差、日益不适应深层储层改造要求的难题,从压裂液耐温性能影响因素分析出发,合成了耐温高、交联时间可调的有机硼锆复合交联剂WD-51D,并通过引入温度稳定剂YA-10研制成耐温能力达140 ℃的高温压裂液体系。实验表明该压裂液体系耐温耐剪切能力强(140 ℃、170 s-1连续剪切120 min黏度保持在100 mPa?s以上),降滤失性能好(滤失系数7.49×10-4 m/min0.5),对地层伤害率低(27.99%),满足川西深层储层改造的要求,并在大邑2井取得了成功应用。

     

    Abstract: Poor temperature resistance of west Sichuan fracturing fluid at present can’t meet the need of deep reservoir reconstruction. Starting from analyzing factors affecting temperature resistance of fracturing fluid, organic borate-zirconate compound cross-linker WD-51D was synthesized with high temperature resistance and adjustable cross-linking time. In addition, this paper developed a high temperature (140 ℃) fracturing fluid system by the introduction of temperature stabilizer YA-10. Experiments indicate that this fracturing fluid possesses the advantage of powerful temperature/shear (T/S) resistance (viscosity maintains above 100 mPa?s at 140 ℃ and 170 s-1 continuous shearing for 120 min), good filtrate reduction property (filtration coefficient of 7.49×10-4 m/min0.5), low formation damage ( 27.99%) and so on. This fracturing fluid can meet the requirement of deep reservoir reconstruction in west Sichuan, and has successfully applied in DaYi 2 well.

     

/

返回文章
返回